Recent content by pcod1970

New interecting fact what I'm sure is linked:Today, we added some extra monitoring on the Q.931 protocol level on PBX side. Doing so, we learned that when a failing inbound call is made, the Telco does send a call SETUP message and it is well received on the PBX's E1 interface (monitoring...

Could a bad earth conection or PRI quality cable or connector lead to such status? There are no alarms reported on the clocks (in sync and no slips). When issue is occuring, channels are becoming one by one LCKO until the links are not usable. For sure I will check the error counters at the...

This is what we already proposed but due to the random frequency of the occurence (it can work for 2 weeks without any issue), customer did not accept to remove the recording solution. It should be indeed easier... now we trying to understand what could be the reasons.

Hi all, We have 2 PRI trunks connected to PSTN. We have then connected a voice multicoupler (Nice product) between the PSTN and the PBX on these PRAs. The purpose of Nice application is to record the calls on the voice channels. From time to time, we are facing to LCKO channels on these...

I wish all of you a merry Xmas and happy new year 2005 from Belgium.

If you need the number of mailboxes you have, you have to retrieve this info from the mail application itself.

To remove DTI2 definition, go to CEQU LD 17 REQ: CHG TYPE: CEQU ... DTI2 X<Loop number> ... Be sure that there is not more trunks defined for this loop. If yes, delete them in OVL 14

Not sure but maybe "H" is coming from "Home". The reason? In Meridian MCDN network (TIE line), private routing can be defined with AC2 access code. In this case, each remote sites can be defined with LOC code (LD90) and local site has its own Home location (HLOC)

MDID means 'No Answer DID calls routed to Message Center". That you can find in the NTP. Default value is NO

To print: LD 21 REQ:PRT TYPE:RDR ... To change: LD 15 REQ:CHG TYPE:RDR ... MDID YES <enter> ... and try

Intercept is already set to att. My atdn defined in OVL15 is 11. I'll search in NTP more details. Thank to try to help me...

I tried it but unfortunately I have the same VM message. MDID is for DID calls not answered. In my case, it is a DID number not defined.

To reset the system, just power off and power on. We will not lose anything. Data are stored on flash memory. There is no battery on CPU card. What you see is a dongle...

xxxx is not the DN but the TN (terminal number) ex: ENLU 10 0 2 1 (Loop shelf card unit) For an opt11 ENLU 2 5 (card unit)

The purpose is, in case of DRP, to send 4000 numbers rerouted by the PSTN from one site to a backup one. Customers calling user DN should receive an emergency message, other will be rerouted to specific destinations. I have 96 Mail channels. If I need to setup ran, it will cost a lot for sth I...