Nit number to voice mail announcment

[pcod1970]

In my PBX setup, I would like that all unused DNs are sent to the NIT number defined in LD15. I have no console defined. So night mode is always active. I've defined a dummy queue 7992 (ncfw Meridian Mail). In MMail, 7992 is defined as announcment. When I'm calling from outside to an unknown number, I receive from MMail "your session cannot continue at this time, please try again later". Any idea what is wrong?

 

[johnpoole]

the mail is seeing the dialed number not the nite number, always been a problem.. you'll need to set up the dialed dn in a idc table for that to work

john poole
bellsouth business
columbia,sc

 

[pcod1970]

In this case, I need to defined 4000 numbers in the IDC! What I want to avoid. Is there a workaround?

 

[johnpoole]

yes you can put numbers in to a block or use a ran for a intercept treatment.. that's what i have set up, a route with 2 ports that say you have reached a nonworking number. look at you rdr data for that option. i would never send 4000 vacant numbers to mail, unless i was trying to sell voice mail ports

john poole
bellsouth business
columbia,sc

 

[johnpoole]

INT_DATA
then ranr prompt tells the switch which route to send vacant numbers to, int and ext

ld 21
prt
int


john poole
bellsouth business
columbia,sc

 

[pcod1970]

The purpose is, in case of DRP, to send 4000 numbers rerouted by the PSTN from one site to a backup one. Customers calling user DN should receive an emergency message, other will be rerouted to specific destinations. I have 96 Mail channels. If I need to setup ran, it will cost a lot for sth I will never use (I hope). It is just a business requierement...

 

[johnpoole]

just found a possible, in your cdb their is a prompt MDID, defaults to no, package 46 opt=mci, no answer did calls routed to a Message Center...

john poole
bellsouth business
columbia,sc

 

[pcod1970]

I tried it but unfortunately I have the same VM message.
MDID is for DID calls not answered. In my case, it is a DID number not defined.

 

[johnpoole]

if you set the intercept treatment to att, build a att with an atdn will that mb get non defined did calls?

john poole
bellsouth business
columbia,sc

 

[pcod1970]

Intercept is already set to att. My atdn defined in OVL15 is 11. I'll search in NTP more details. Thank to try to help me...