I'm trying to configure a ISDN connection to OCS through a Audiocodes 1000 gateway. We've been succesfuly using RB but that doesn't pass caller ID. So far I've managed to pass caller ID but no voice and the call drops with 1166 and 1164 error codes. Anybody have any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
G3 R9 to Audiocodes 1000 gateway
- Thread starter nscnsc
- Start date
- Thread starter
- #4
Thank you for your response.
In regards to timing isssue. The gate looks to the PBX for timing, but the DS1 connect is set to network. All ports show inservice. I have tried setting the board to line-side but the ports stay out of service after its released.
In regards to error messages.Errors from the PBX are:
1166 Abnormal ISDN Drop
1164 ISDN reject.
Again thank you for your interest.
In regards to timing isssue. The gate looks to the PBX for timing, but the DS1 connect is set to network. All ports show inservice. I have tried setting the board to line-side but the ports stay out of service after its released.
In regards to error messages.Errors from the PBX are:
1166 Abnormal ISDN Drop
1164 ISDN reject.
Again thank you for your interest.
- Status
Similar threads
- Question
- Question
- Locked
- Question