CM6 Utiltiy Server and TFTP for 46xx phones

[Stinney]

We're now installing CM6.3 S8300 servers in gateways because CM5.x is no longer available. CM 6.x now uses the Utility Server as the TFTP and HTTP server for the 46xxsettings.txt file.

Can anyone confirm/provide the following:

1) For 46xx phones using Option 176, where does the 46xxsettings.txt file go on the Utility Server? What's the default directory to put this file into on the utility server?

2) If we are using the default directory (which I hope you can answer in #1) we don't have to put the TFTPDIR= in the DCHP Scope?

3) For HTTP same question for option 242, where is the default directory for the 46xxsettings.txt file on the utility server?

4) Can you confirm the DHCP Scope would be like this if we're using the default directory, or if we are using the default do we not have to put it in the string just like the TFTPDIR:

MCIPADD=x.x.x.x,L2Q=0,L2QVLAN=x,PHY2VLAN=x,MCPORT=1719,HTTPSRVR=x.x.x,HTTPDIR=/,VLANTEST=60,OPSTAT=011

5) Finally, shoudl the MCIPADD include the LSP IP address and not just the Core PBX? So it would be: MCIPADD={core pbx ip},{lsp ip},L2Q=0, etc, etc, etc.




- Stinney

“The man who asks a question is a fool for a minute, the man who does not ask is a fool for life.” - Confucius

 

[IPOthermia]

I leave the LSP address out of the SSON strings.

 

[lms4]

Good morning Stinney.

Did you ever get this figured out? My trouble is that Utility Services has the ability to upload a 46xxsettings file via the DHCP portion, what about the file to be used for Option 176 TFTP phones? Would I have to upload this file in the Upload Gateway Firmware section? And would Option 176 have to point to the /tmp directory (TFTPDIR=/tmp) ?

Thank you for your time!

 

[Stinney]

I believe we determined that it is the TFTPDIR=/tmp directory.

- Stinney

“The man who asks a question is a fool for a minute, the man who does not ask is a fool for life.” - Confucius

 

[avAyATEKky]

3) For HTTP same question for option 242, where is the default directory for the 46xxsettings.txt file on the utility server?

4) Can you confirm the DHCP Scope would be like this if we're using the default directory, or if we are using the default do we not have to put it in the string just like the TFTPDIR:

[highlight #CC0000]DHCP 242 - MCIPADD=x.x.x.x,HTTPSRVR=x.x.x.x,L2Q=1,VLANTEST=xx
When using the Utility server a lot of options will be default not needed in the dhcp scope[/highlight]

5) Finally, shoudl the MCIPADD include the LSP IP address and not just the Core PBX? So it would be: MCIPADD={core pbx ip},{lsp ip},L2Q=0, etc, etc, etc.
[highlight #CC0000]I have my sites HTTPSRVR= the Utility Server address, not CM/ESS/LSP[/highlight]

Today Makes Tomorrow