Recent content by TGW

I can access the box from other phones, so I doubt that I don't know the default password (after all, I just created some 30 mailboxes after I installed the thing). I'll check the title of the manual I was reading.

Yes, mbox 211, x 211. I did that, and that, and that. I can access the mailbox, but not from that phone without hitting 'other', typing the extension (mbox number) and password, which I'd rather not make the person do (just trying to keep it simple for those I serve). I did a search of the...

We had some trouble with a mailbox, not being able to get in, whether this be related to user forgetting password or not, I don't know, but now after I reset the password in the F983 menu, the phone still says Mbox Locked ... Contact admin, after entering any password. Accessing the mailbox by...

Working now. Thank you all for your intelligent answers.

It is 6.1 MR I just did startup, with the same results The sleeve says it's a NTBB08GA-93 02 2004/05/20 I'm working on it, and I think the "auto" may be working. BRB

I think I'll do that and see what happens. I was hoping for a quicker solution, but if that's what I have to do, such it is.

Could the software be bad? Worst case scenario, how can I revert to an R1T1 again on this KSU?

Outgoing calls are working.

It gives busy without target set.

Upgrade process: 1) power down 2) switch s/w R1T1 to R6.1 3) login and set time 4) figure out where things are and start programming the outside lines 5) target lines weren't working right, so I decided to give a punch in the dark and put the new (to us) 0X32 in, with software and all our cards...

Line001 Trunk type: E&M Line type:Pool A Dial mode:Tone PrimeSet:none Dstnct rng: None Auto Privacy:Y Ans mode:Manual Aux. ringer:N Signal:WinkStart ANI Number:Y DNIS Number:Y Without the prime set, it just rings and rings, but otherwise it goes to the prime set. Line157 (target line)...

The card is properly configured for T1. Line001, the first channel, is on port 201, just as it was on the old system.

Almost sound like our system. I believe that any NAM newer than the KSU software will work. I just used a fiber NAM 4.1 on R1T1, without any incompatibility problems; I'd go the full upgrade to the newest, so the possibility of upgrading the system software in the future will be left open.

I got them all above 157. E&M. DID didn't work, either. Do I need to enable the target lines?

I just upgraded our R1T1 to 6.1, and now the target lines aren't going to the right places-- the call comes in on the T1 channel 1, and then goes to the prime set for that channel, instead of the prime for the target line. I'm not very familiar with the 6.1 (not at all), since I've just been...