Recent content by texan01

Thank you. I was afraid of that.

We currently have a CS1000 system and are thinking about replacing with the Avaya Aura G-series platform. Meaning changing over to the G450 and 430 gateways. We currently use the i2001 and i2002 phase II phones. Does anyone know if these will work? I read where only the 96xx, 4600, and 1600 will...

Will Call Pilot Desktop Messaging work with Microsoft Office 365. Call pilot is a 201i on release 5.0? Thanks.

Thanks for the response but not using a modem, getting on their network and using putty to log in. I looked at all the settings for my putty session as compared to a working one and looked at the tty settings for the PBX. All the same.

Ok, I have a weird problem that just started. I have several CS1000E's that I take care of but on one of them when I putty into it and do a mdp issp for example, I get the info all together and not by lines, like below. I outed my saved session and rebuilt it but still does the same thing. I...

Thanks for the reply but I think i figured it out. Seems under PARM settings there is a MSEC prompt. It needed to be set to off. The reason the IP phones worked was because under their CLS setting it has MSNV. MSEC (ON) OFF Enable Media Security for the system. Disable Media Security. The...

I have two cs1000e rel 7.5 fully patched connected to to a 1000M via session manager using sip trunks. Problem I am having is I can not access the ms lync number from tdm phones on either E. I can access it using IP phones from either the e's or the m. I can access it from tdm phones from the M...

Getting these same errors........anymore news for anyone to share??

Customer replaced older 2246 gateway with a newer version, before when the wirless phones received a text message it automatically appeared on screen. Now they have to hit a button to make message appear.Not sure if it's a configuration issue or if that's normal. Any feedback will be...

Ok, but how can I send a call that is unanswered after a couple of rings to a RAN recording saying " Operator is currently assisting other calls ...blah, blah" and somehow get sent back to MCR key. I do not see a way to make that happen.

Trying to come up with a solution to replacing the M2250 console with an M3904 phone. I know that I can build an ACD que with 0 as the number but here the deal. They want to be able to put a call on hold while they answer another call. Pretty sure ACD won't allow that. So basically want several...

Ever since upgrading an Option 11 to a CS1000e I have been having trouble getting a page to come across a tie trunk attached to a BCM50 rel.1 via a point to point T-1. It worked before the upgrade so I am thinking it's on the CS1000 end. I have the paging trunk configured as a pag trunk, even...

I will provide ran route and trunks when I can get back out to customer site. Like I said it's been working, just all of a sudden quit. I am the only one that's does programming on it. I can dial the acod and get the announcement also. Thanks, will post other info later.

Been working on a recorded overflow announcement that all of a sudden quit working. The little digital announcer lost it's recording so I re-recorded it and now I can access it by dialing access code but when I get a second call to the 2250 console it just keeps ringing until they after it. I am...

Thanks, actually was trying it on my system I have set up in my lab, no wonder it doesn't work. I need to upgrade.