I'm having the same problem now with a G3SI version 11. Just got off the phone with AVAYA and guess what, the new firmware hoses the 4620 phone to where it won't work with the V11 CM. I have tried everything and I continue to get the wrong set type error. So, what I ended up doing was sending...
Do a "list trace station xxxx" on the voicemail port (use the extension for that port) that you are using for testing the outcalling. That should give you a little more information.
If you get nothing returned on the trace, that means that Audix is not even able to transfer the call to the...
Hmmm...I see what you're saying but what about this? When I first plugged the line into the phone, the switch had no idea what extension I wanted to use because it wouldn't even let me break dial tone. My UDP is setup correctly so I'm thinking it has to do something with what the phone comes...
Update on this...The TTI feature is now working after manually assinging the port to the station.
So, I guess I'll just have to manually assign all the phones and then they'll be good to go from there on out.
Thanks
Mike
Hi all,
I just got 10 "serialized" avaya 6408D+ phones from a vendor that I normally do not buy through.
I'm trying to get these to work on my G3SI Version 11 with a TN 2224B ciruit pack.
The problem is that I can't break the dial tone to TTI the phone. I checked line polarity by making a...
I do mine this way. I change the coverage path that is attached to the night service exension. So, instead of point 1 being our audix hunt group for the auto attendant, I put point one as being the extension I want to route calls to and point 2 as the audix hunt.
Easy change to make...the...
I use these tapes from HP.
HP C4425 Data Cartridge.
Preformatted 8GB/TR-4
8 GB Compressed/4 GB Native
Travan Technology
Avaya will tell you this tape doesn't work but I've been using them for years. They're roughly 25 bucks each. I bought my last ones at Frys in California about a month...
I've been pretty disappointed in the AVAYA certs. I've been working on AVAYA equipment for a few years now and I just see it being so specialized for my area that I live in. I think we are 1 of 2 companies that run AVAYA gear in our small town and I just see it not buying me a whole lot. Now...
You know what's weird about this is that when it's up and running, which is 99% of the time, it works as advertised and you would never suspect anything is mis programmed or setup incorrectly. Then, out of the blue, it's trying to route out over our internet connection via 6x.xxx.xxx.xxx which...
Update on resolution
I brought AVAYA in on this to get it fixed as it's covered under my 8x5 maintenance contract with them.
busy trunk 23 on both ends
release trunk 23 on both ends
busy sig 23 on both ends
release sig 23 on both ends
test sig 23 on both ends
reset packet-inter 2
We tried the...
Hi all,
One of my IP trunks have just gone down between location a and location b. I have done the following but the trunks will not come back alive.
busy trunk 23 on both ends
release trunk 23 on both ends
busy sig 23 on both ends
release sig 23 on both ends
test sig 23 on both ends
results...
Hi cwjr
All of my trunks are isdn-pri and the "attd" entry sends all unassigned DID calls directly to my attendant. I'm not sure what's wrong with yours but wanted you to know it works at my installation.
Mike
Thanks mrdenny,
We use ADP and with your recommendation I found this link.
Thanks for getting me started.
http://www.majoraccounts.adp.com/expense/index.htm
Mike
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.