Guest_imported
New member
- Jan 1, 1970
- 0
I have the equiptment and need to know how to wire from the 66 block to the customer premise.. ie.. the existing phone lines coming in... any help will be appreciated....
thanks
marcy
thanks
marcy
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
I need the wiring schematics for norstar compact ics 4.0 1
- Thread starter Guest_imported
- Start date
- Status
MWM
MIS
- Aug 9, 2001
- 200
Documentation for Nortel is readily available from sources on the Web. Search Nortel. $50-$75 for the docs, mailed, not downloaded.
Be aware, though, that the number scheme may not make sense at first. If time is valuable, you might need to hire a tech to install it.
The good news is that Nortel is hard to damage by miswiring.
Be aware, though, that the number scheme may not make sense at first. If time is valuable, you might need to hire a tech to install it.
The good news is that Nortel is hard to damage by miswiring.
-
1
- #3
on a compact ics the co lines feature as follows
line 1 W/Bl and Bl/W
line 2 WO/ and O/W
line 3 W/sl and SL/W
line 4 R/Bl and Bl/R So it goes 2 and skips 2 for a total of 8 lines.
The station side feastures out on the 4.0
port 101
port 102
port 103- thru port 116 for a standard config. Jeter@LasVegas.com
J.Fisher CCNA
line 1 W/Bl and Bl/W
line 2 WO/ and O/W
line 3 W/sl and SL/W
line 4 R/Bl and Bl/R So it goes 2 and skips 2 for a total of 8 lines.
The station side feastures out on the 4.0
port 101
port 102
port 103- thru port 116 for a standard config. Jeter@LasVegas.com
J.Fisher CCNA
MWM
MIS
- Aug 9, 2001
- 200
... Nortel uses the simplest possible termination: the single pair per station is terminated on the primary pair position of the jack you are using.
For an 8-pin jack, the primary pair position is, as you say, pins 4&5. For USOC jacks (4 or 6 pin), the primary position is the center pair of pins.
Likewise, the CAP module lays down on the secondary pair positions.
Yours,
Mike
For an 8-pin jack, the primary pair position is, as you say, pins 4&5. For USOC jacks (4 or 6 pin), the primary position is the center pair of pins.
Likewise, the CAP module lays down on the secondary pair positions.
Yours,
Mike
- Status
Similar threads
