I just upgraded to CM2.0 and now the VM lights don't work for one site. Site 1 which is a G3 with the Intuity Audix system, works fine. Site 2 which is now an 8100 from an IP600 no longer gets VM light messages. I have checked the signaling group between the two and it looks fine, but the data extensions were changed in the signaling group. What else can I check?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Voice Mail Lights between switches
- Thread starter cmeyer
- Start date
the data extension was changed in both systems? Is the node correct in the Intuity and both pbx s and the link it up on both sides?
My name is David, and I have approved this message.
P.S. A message to all,if you want to get the best response to a question, please read FAQ222-2244 first. Also give the type and version of your voice mail & pbx system & preview your post to make sure it is complete & understandable.
My name is David, and I have approved this message.
P.S. A message to all,if you want to get the best response to a question, please read FAQ222-2244 first. Also give the type and version of your voice mail & pbx system & preview your post to make sure it is complete & understandable.
- Status
Similar threads
- Locked
- Question