I am trying to setup my Val board to access via FTP
already setup an ip-add on node-names
already setup ip-interfaces and also setup ethernet-options for full duplex speed
enable ethernet port on ip-interfaces
everything is setup correctly
try to ping that ip-add or node-name for that board and fails
error code 1007
dont know what else to do
check other val boards and all of them have the same configuration same firmware everything looks fine and those works
change ethernet cable from my val to the switch, check switch configuration and looks fine
just dont know what else can be
thanks!
Board Information
VAL-ANNOUNCEMENT
TN2501AP
HW02
FW006
S8700
G3 v11
g600
already setup an ip-add on node-names
already setup ip-interfaces and also setup ethernet-options for full duplex speed
enable ethernet port on ip-interfaces
everything is setup correctly
try to ping that ip-add or node-name for that board and fails
error code 1007
dont know what else to do
check other val boards and all of them have the same configuration same firmware everything looks fine and those works
change ethernet cable from my val to the switch, check switch configuration and looks fine
just dont know what else can be
thanks!
Board Information
VAL-ANNOUNCEMENT
TN2501AP
HW02
FW006
S8700
G3 v11
g600