Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using procomm to program

Status
Not open for further replies.

gshaheen

Vendor
Apr 22, 2001
107
US
Can someone tell me what the settings in Procom would need to be in order to program the Definity system via the serial port on the back of the system. The original AT&T terminal is dead. Looking for Baud rate, terminal type, parity, stop bits, data bits, etc...
Thanks!
 
I am using Procomm Plus(old DOS version 2.01) and I like it.
To work with it you need only change key mapping for 5 keys (Alt+F8 in Procom PLus):

KEYPAD - ^[OM (Help)
KEYPAD / ^[Ow (Cansel)
PgUp ^[[V
PgDwn ^[[U
KEY ENTER ^[SB

good luck
 
Hi gshaheen,

The settings you need are 8-N-1 and terminal mode 4410.

Hope this helps,

Chris
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top