I am aware of the ad issue if you try to upgrade ad2000 to ad2003 and you have exch 2000 running, that it mangles 3 non rfc complient attributues. In MS q325379, they state that this WILL NOT be the case if you have applied Exchange 2000 SP3 to your exch 2000 server. Can anyone confirm this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
upgrade to AD 2003 and exchange 2000 1
- Thread starter johnrmcc
- Start date
-
1
- #2
- Thread starter
- #3
Yes. Since I had already applied SP 3 to Exchange it didn't actually change anything, but with this type of change I wanted to be sure everything was right.
Plus, when I first started looking at that article last year for an upgrade of my test environment, it had two problems: 1) It didn't mention that Exchange SP 3 corrected the problem 2) The LDF script was incorrect. They updated the article a few months later (before I did the upgrade in production) so that made me even more cautious. Everything did work fine though.
Plus, when I first started looking at that article last year for an upgrade of my test environment, it had two problems: 1) It didn't mention that Exchange SP 3 corrected the problem 2) The LDF script was incorrect. They updated the article a few months later (before I did the upgrade in production) so that made me even more cautious. Everything did work fine though.
mlichstein
MIS
The script (as you have seen) is not necessary if Exchange is at SP3
- Status
Similar threads
