NEACderthalMan
MIS
Hey folks!
I have a Definity G3Si V12. We opened a short-term office some time ago. The users were allowed to get their pre-existing extensions ported over to that system, since we had same area code and prefix. But the system there is not connected to our Definity. I put entries in my Uniform DialPlan that said if you see 58xx, insert the prefix in front of it, thereby making the 4-digit dialing "seamless" to the users at our existing campus. Now we have begun mandatory 10-digit dialing in my area due to area code overlay. The Uniform DialPlan will allow only 4 total digits to be inserted. I need it to be 6, as in if you see dialed digits 58xx, insert 336xxx (area code and prefix).
Does anyone have a good solution that can be implemented to keep the "seamless" 4-digit dialing?
Thanks in advance for all you do
I have a Definity G3Si V12. We opened a short-term office some time ago. The users were allowed to get their pre-existing extensions ported over to that system, since we had same area code and prefix. But the system there is not connected to our Definity. I put entries in my Uniform DialPlan that said if you see 58xx, insert the prefix in front of it, thereby making the 4-digit dialing "seamless" to the users at our existing campus. Now we have begun mandatory 10-digit dialing in my area due to area code overlay. The Uniform DialPlan will allow only 4 total digits to be inserted. I need it to be 6, as in if you see dialed digits 58xx, insert 336xxx (area code and prefix).
Does anyone have a good solution that can be implemented to keep the "seamless" 4-digit dialing?
Thanks in advance for all you do