T1-WIC DSU/CSU Hardware is "?"

[RLEE5]

Greetings All:

I have several 2600 class routers with T1-WIC's installed on Frame-Relay. When I SHO INT on most of them the line "Hardware is.." reads "PQICC". I have some new WIC cards that read "DSCC4".

Is this just a different chipset maker?

Thanks
R.Lee

 

[wybnormal]

There are two different T1-WICs and they are not interchangable (as I found out the hard way). One is for the older 2600s and the new one is for the newer replacement models of the 2600 series (maybe others but I have not tested them) They look the same but the new card in the old router will not work. You might have a mix of old and new??

Just a thought.

MikeS

Find me at

http://www.packetattack.com

"Take advantage of the enemy's unreadiness, make your way by unexpected routes, and attack unguarded spots."
Sun Tzu

 

[farsouth]

You also have to make sure you are running ios 12.3 at the very least, for v2 of the cards.

 

[RLEE5]

Is the "DSCC4" WIC the new V2 module? These are going into 2611XM routers.

 

[farsouth]

If it is a v2 card, it should say v2 in the bottom right hand corner of the card. Atleast ours did.

 

[wybnormal]

Should and do are two different things.. mine did not That caused a bad case of heart burn for the afternoon.

MikeS

Find me at

http://www.packetattack.com

"Take advantage of the enemy's unreadiness, make your way by unexpected routes, and attack unguarded spots."
Sun Tzu