StarTalk Flash and MICS 2

[dkediger]

For some reason, our Flash seems to have "flashed."

MICS no longer recognizes the Feature codes, so I can't access it that way.

I've reset both systems, MICS through System restart and FLash with a power reset.

I get a Log: prompt on the DN for the Flash, but none of the passwords work there.

Any possibilities other than the unit is FUBAR?

 

[curlycord]

Press Feature 983, if it says Pswrd: then it has defaulted and needs to be re-programmed from scratch.

 

[dkediger]

All the Feature 98x codes are showing "Inactive Feature"

 

[curlycord]

Try Feature 906

 

[dkediger]

Same result.

Thanks for your assistance, BTW.

 

[curlycord]

Check all wires and connections, look to see a light is on the flash.

 

[Norstarguru]

Try FEature 903


norstarguru

http://www.1stalliancecom.com

 

[dkediger]

Power is good - have indicator light on Flash unit.

Connections appear good. I can get a Log: prompt on the Norstar DN than Flash is using, but it won't accept any password I have or the default Config or 0000

 

[Norstarguru]

If that does not work try F985
9
Then enter the following with the keypad

RESETSMPSWD

Press ok

This should reset you Pswd do factory default to match your extension DN Length

if your extension #'s are 2 digits 120000
if your extension #'s are 3 digits 1020000



norstarguru

http://www.1stalliancecom.com

 

[dkediger]

Feature 903 just gave me the Feature list showing 980-989 Once, now its showing "Inactive Feature" as well.

 

[dkediger]

OK, now I'm in with F983 and Config. Apparently viewing F903 and confirming those codes reset what I needed.

Thanks!

 

[curlycord]

Yes sorry F903....your system has defaulted.

 

[Norstarguru]

That tells me the system got spiked or somone is not deleting their messages which is really important on the Flash because of it's limited storage capacity. As far as the install screen, just hit ok and next then ok to config it.
And you should be good to go.




norstarguru

http://www.1stalliancecom.com