SSH to CS1000ELAN IP

[dixiedogger]

I have been upgrading some pbx's to 5.5 and noticed I was getting some messages about ssh so I figured I would give it a shot. So I fired up putty and logged right into one of them with no issue using admin1 and admin2. Then I tried the other one and it keeps saying access denied. They are both on the same release. The only difference is one is a cs1000e with cppm and the other is cs1000m with cpp4 processors. Any idea what makes the ssh work? Is there something I am not aware of that is enabled on one switch that is not enabled on the other?

 

[pronei]

USe RLogin for 1000M's

Use username CPSID for Rlogin.

 

[dixiedogger]

Yes I know about the rlogin but is the offical answer ssh is not supported on the 1000m? Seems odd because it connects and ask for username I just cant seem to find a user and password it likes? Seems I may just need to give ssh access to a user or something like that?

 

[dixiedogger]

Come on Fletch you still around? I know you would know this.

 

[Avaya911PLM]

Should work just fine! Possibly you are out of PTY ports or they are not defined on the the switch.

SSH is available on 5.0 and higher. Not a hardware dependency at all. It's in the software. Both cores are running VxWorks.

--
Fletch

Nortel Emergency Services PLM

http://nortel.com/e911

Check out this month's E911 Talk podcast at Nortel E911 Talk Podcast

 

[dixiedogger]

Thanks I know you would know.

 

[GTexx]

We have 4 CS 1000M's and 1 CS 1000e, I am able to SSH to all of them. They are all running Release 5.5