Some VAL announcements do not work

[slovic]

Hi all,

We migrated G3r system to S8700 server platform, and since then we are expierencing strange behiveour of VAL board. From time to time (approx. once in two weeks) some announcements stop working, just busy signal, an others are working fine. There are no alarms whatsoever, and board tests (long, repeat) are ok. Reset board helps but that is not a solution. Board firmware is latest one, and system is on CM 3.0.1 with latest patch. Also, board is compatible with CM sw version, according to hardware compatibility matrix.

Any ideas..?

Thanks,

 

[lever]

You may already have checked, but does the Annc have Q enabled?
lever.

 

[slovic]

Well, lever, you might be right!
I noticed that today, so I changed Q to y....
It is an inherited system, I didn't check the obvious
Thanks, I hope it will work now