idahomitel
Technical User
Is it even possible to separate channels in a PRI to facilitate separate trunk groups for outgoing caller id naming or any other application?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SIP/PRI SX 200 ICP Dividing channels for different trunk groups
- Thread starter idahomitel
- Start date
gbiddlecombe
Vendor
You can put channels in different trunk groups.
Outbound CPN is handled in form 19 tenants.
Try setting up another tenant for one set of trunks, setting the CPN.
Changing the tenant for certain channels in form 15 then put those trunks in their own TG.
One challenge might be, incoming is either ascending or descending and may conflict with your outbound groups?
Outbound CPN is handled in form 19 tenants.
Try setting up another tenant for one set of trunks, setting the CPN.
Changing the tenant for certain channels in form 15 then put those trunks in their own TG.
One challenge might be, incoming is either ascending or descending and may conflict with your outbound groups?
Might be possible, caller id might be difficult unless only 2 numbers are needed and it could be done at the carrier
Not sure if tenant for the trunk would override station tenant for caller id but it might be something to try. I would help to know what you are trying to accomplish.