SES 3.1 IP Address change 1

[phonetech1]

Hi
I have a 3.1 SES server that is teamed with an 8300.
We are changing IP addressing on our network.
I've already changed everything on the 8300 and it is up and running, but I can't figure out how to change the IP address of our 8500B based SES server.
THanks

 

[mrjedi]

from shell run the initial_setup command

 

[Mitch672]

If it's like AES, then you would run "netconfig" from the linux prompt...

mitch


AVAYA Certified Specialist

 

[phonetech1]

Mrjedi, thanks for your help. It worked. It must've been a tough question, since nobody else had an answer.
One guy from a different forum tried to help me and that's it.
Thanks again.

Mitch627, I've tried netconfig, but it didn't change the address. After the reboot the address was still the same.

 

[telcomwork]

Depending on moving out of the subnet or network you may need to change the default GW as well...

View
cat /etc/sysconfig/network

Add
route add default gw xxx.xxx.xxx.xxx eth0

 

[phonetech1]

initial_setup menu had a default gateway field.
I made all my changes in that menu.