Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SCN Hunt Groups

Status
Not open for further replies.

mjwilson12379

IS-IT--Management
Joined
Oct 5, 2003
Messages
113
Hello....
We are doing a massive network of three SCNs with 20 nodes in each SCN. THat is the simple part thus far.

SCN:
What we are running into is the main site is a 412 with 2 PRIs and routing out to each node from there. We want the call to route like we do at non networked IPOs, so try to follow below: (have to use the 'vm:fultonincoming' so the caller hears rings... damn assisted transfer doesn't ring)

-Call comes in on DID 9060 at host site
-Goes to VM:FultonIncoming
-If condition is false (closed)
-go to VM:FultonAA
-If condition is true (open hours)
-Ring hunt group 59059 at the remote site (ip406)
-If answered, great, done
-If not answered, goes to VM:FultonAA

Problem is the host site doesn't recognize the 59059 as a valid ext/hunt group. The SCN is up, the two sites are aware of each others ext, just not the hunt group. And I of course cannot do the hunt group on the host site, becuase you cannot specify extensions not on that local system.

Help!!!!
 
Try creating a system short code that take the form 59059/Dial and set the line group to match the Outgoing Group ID of the IP trunk to the remote site.
 
Ahh, yes, that seems like it should work. Was thinking too basic. Unreleatd note, but to use a shared VM Pro, do you have to be in a SCN?
 
Thank you sizbut, I can now get the calls ringing via the shortcode over the trunk to the remote site, the problem is, however, that if no one picks up, then we get stuck in a cycle:
668203mS CMTARGET: SELECT:6 NO TARGETS, TRY VOICEMAIL
668203mS CMTARGET: SELECT:6 NO TARGETS, ROUND AGAIN
668203mS CMTARGET: SET HG:6 FultonReception orig=0
668203mS CMTARGET: ADD HG:6 FultonReception (depth=1 B=1)
668203mS CMTARGET: CHK HG EXCEPTED:6 FultonReception count=0
668203mS CMTARGET: ADD USER:6 Fulton Operator(59060, state=Ringing) (depth=2 B=1) cw=0 allow redirect = 0
668204mS CMTARGET: SELECT:6 SEND SETUP (clearing old=0)

I have, in VM pro at the host site, a start point, leave that transfers performs a goto to the main AA for FultonReception.

any thoughts?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top