probietech
Technical User
I just need to know if there is anything I need to do other than take the old card out and replace the new PRI card??? Do I need to disable anything first??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Replacing dual port DTI/PRI cards 1
- Thread starter probietech
- Start date
- Status
I'm certain you could just pull out the old and put in the new, but you 'should' disable each loop first.
--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--
--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--
-
1
- #3
bigindian65
Technical User
dis Dchs in 96, loops in 60 face plate dis dual pri card. make sure dip switches match old card, install new card face plate disabled, and reverse proceedure.
Mato' Was'aka
Mato' Was'aka
nhphoneguy
Technical User
Also, if you have a dch daughter board, disable the MSDL in 96 first. I have seen this cause an init if the card is just yanked out.
- Thread starter
- #5
probietech
Technical User
Thank you all so much!! I just wanted to make sure I didn't screw anything up too bad!!! The cards are replaced at this location and I'll replace the other cards hopefully later today!!
Again, thank you all so much for your help always!!!
S.
Again, thank you all so much for your help always!!!
S.
- Status
Similar threads
- Locked
- Question
- Locked
- Question