Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
RAS Instructions for S8300
- Thread starter chs89
- Start date
There a two steps: first you need a RAS dial-up connection. Go to your Control Panel and add a new dial-up network connection. On the security tab make sure the option "Terminal" is checked. Leave the rest at default.
After dialling in you should get an icon in you system tray representing the network connection. When you check the properties you can see the IP address of the server.
Step 2 is to add a switch in ASA using the network connection option and the IP address you just wrote down.
Keep in mind that you will need a login and password for the RAS connection AND a login and password for logging in to Communication Manager. These are not necessarily the same.
Good luck. Hope this helps somewhat.
After dialling in you should get an icon in you system tray representing the network connection. When you check the properties you can see the IP address of the server.
Step 2 is to add a switch in ASA using the network connection option and the IP address you just wrote down.
Keep in mind that you will need a login and password for the RAS connection AND a login and password for logging in to Communication Manager. These are not necessarily the same.
Good luck. Hope this helps somewhat.
- Status
Similar threads
- Locked
- Question
