pause error messages 1

[technickelone]

Anyone know of a way to pause error messages until I am done entering a command? Can't stand trying to figure out where i am in the command when bug messages keep popping up.

Thanks

 

[bigindian65]

go to ld 17 and chg adan tty xx whichever one you are using.
xbug xsch xmtc on the USER prompt.

Mato' Was'aka

 

[technickelone]

this will not stop them all together will it. I just want to pause until I finish typing

 

[PERRYPJ]

That's the only way to stop them, you put them back after your through. If you getting that many errors someone needs to take a look at it

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[janaya]

I'm with Perry. why not try to figure out why you are getting BUG messages. You can ususally find a patch to correct just about any BUG error.

Remember "out of sight out of mind" doesn't work that well with the PBX equipment.

 

[GHTROUT]

Shift + one star" will at least get you to the prompt you were at, so you can start that bug-interrupted line over.



[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators