Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Off Premise call forward
- Thread starter txteck
- Start date
Need more info. How did you program the system for external call forward?
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #3
So you're just doing F4 + the phone number? You should have to use a destination code with routing. When you call forward you should be dialing F4 + destination code + telephone number.
F84 (line redirection) can only be used with lines that appear on the telephone. The extension must have redirect allowed, and lines involved in the external transfer must have supervision activated.
Brian Cox
Oregon Phone
F84 (line redirection) can only be used with lines that appear on the telephone. The extension must have redirect allowed, and lines involved in the external transfer must have supervision activated.
Brian Cox
Oregon Phone
- Thread starter
- #5
When I forward it to 832+7. I do Feature 4 823+7 no problem and 1+902+7 no problem. 713 is a local area code, I forward it but when I call the DID I get a fast busy. SO what do I need to do to add all the other area codes in the United States? Thanks
- Thread starter
- #6
Create a new route under Services - Routing Services - Routes (002, for example). Dial out will be none, but there is a glitch in programming so temporarily enter F78 here. Then enter the line pool to be used for forwarding (pool A or PRI-A, etc).
Then go to Services - Routing Services - Destination Codes to create a destination code (7, for example). Under Normal Mode assign the route (002) you crested above.
Go back to Routes and change the dial out for route 002 to none.
If extensions have redirect allowed and line pool access allowed you are all set. To forward you will then dial F4 + destination code (7) + telephone number.
Brian Cox
Oregon Phone
Then go to Services - Routing Services - Destination Codes to create a destination code (7, for example). Under Normal Mode assign the route (002) you crested above.
Go back to Routes and change the dial out for route 002 to none.
If extensions have redirect allowed and line pool access allowed you are all set. To forward you will then dial F4 + destination code (7) + telephone number.
Brian Cox
Oregon Phone
- Thread starter
- #8
You dial F**266344 and then the default password? It works, but it's not the system password? I'm not understanding this.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #10
The previous telephone person has changed the system cordinator password. I was trying to see where a DID had as a prime line. When I went to lines==it came up--lines-- showed lines--then it came up==line name 1XX and that was it. And then I started on the other problem, I could only enter Feature 7. Thanks
- Thread starter
- #11
When you enter the line number (001, for example) it will display Line 001:<name>. Press the SHOW button at this point and you'll see Trunk/Line Data. Press SHOW again to see or change options.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Thread starter
- #13
curlycord
Programmer
Is there a CHANGE on the display?
maybe your using admin password and not config?
=----(((((((((()----=
curlycord
maybe your using admin password and not config?
=----(((((((((()----=
curlycord
- Thread starter
- #15
- Status
Similar threads
- Locked
- Question