merlin magix

[JZJerry]

i have magix with two cabinets in one i have 3 dig 12 station cards analog card and 1 t1 card in secend i put vm (12 ports) i add all ext to calling group 30 ,and i add ext 595 (main vm numer) My queston is how i can add vm ports

 

[TouchToneTommy]

You'll have better response if you post your question in the Merlin fourm.

If I read you correctly, you have added Merlin Messaging in the first slot of the 2nd cabinet.

The next steps are to put the extension ports of the Messaging into a calling group. Do you have a 12-port license card installed? Anyway, under Extensions - Group Calling - Members, you assign the extension ports.

Then under Group Type, assign it as Integrated VMI.

Under Hunt Type, make it Linear.

Also under Group Calling, make the voice mail calling group be the receiver for a Coverage Group, usually group 30.

Under Extensions, you must make the Messaging ports "Rotary Enabled"

Then assign the phones that have voice mail boxes to cover group 30.


Here's a cut-n-paste of a setup page:

Merlin Messaging Initial Programming
Create Calling Group, Assign Group Members, Enable Rotary Signalling
F1 - SysProgram
F5 - Start
F6 - Extensions
PgUp - More
F4 - Grp Calling
F9 - Members
770 - Enter extension number of group
F10 - Enter
Enter group members in Ascending Order (use Ext. No., Log. ID, or Slot/Port)
F10 - Enter - Repeat for all ports
PgDn - Inspect - Verify all ports are listed in order
F5 - Back
F1 - Hunt Type
770 - Enter extension number of group
F10 - Enter
F2 - Linear
F10 - Enter
PgUp - More
F1 - Group Type
770 - Enter extension number of group
F10 - Enter
F3 - Integ VMI
F10 - Enter
F5 - Back
F5 - Back
PgUp - More
F7 - RotaryEnabl
Enter Rotary Extension (Voice Mail Ports, use Ext. No., Log ID, or Slot/Port)
F10 - Enter - Repeat for all ports
PgDn - Inspect - Verify all ports are listed
F5 - Back
PgUp - More
F4 - Grp Calling
F3 - Group Coverage
770 - Enter extension number of group
F10 - Enter
30 - Enter Coverage Group Number
F10 - Enter
PgDn - Inspect - Confirm Coverage Group
F5 - Back
F5 - Back

 

[JZJerry]

thanks very much