ISDN PRI Definity V6

[bige3613]

We are trying to bring up an ISDN PRI on an SCC V6. The phone company has configured a DMS100 that's emulating a 5E/NI-1. D and B's will not set up at all. When we both were NI-2 before, the D and B's will set up showing in-service, but we get fast busy going out...and regular busy coming in. My understanding was that we needed AT&T custom when using the Processor Intfc. Any thoughts will be VERY appreciated!!!
E

 

[4merAvaya]

On the DS-1 form:

Protocol A = AT&T Custom (4ESS)
Protocol B = NI2 (5ESS)
Protocol C = DMS250
Protocol D = DMS100

On a G3si you have two choices:

Use a DS-1 board and a port on a Processor Interface board (TN765).

Use a TN464 board and have the Packet Bus (TN778) installed. This also requires the ISDN over PACCON feature bit be set on the Customer Options screen.

Kevin

 

[bige3613]

Kevin,
Thanks for the response!! The LEC did finally find one issue on their side late last nite, so we are back to testing this AM...We don't have PACCON on, so we are using the TN765 Proc Inftc method. DO you know if this will in fact work with NI-2, or must it be Custom?
Thanks, again!!
E

 

[4merAvaya]

I have not had any issues with protocol and therminating the D channel.

Kevin