IP DECT RBS V2 Set up

[texmatlock]

I am attempting to set up one of these.
Its new. Will be the only one on the system.
I've followed directions from a previous post on here.
When in the configurator I fill out the appropriate info then hit "Send Configuration", and get a message at the bottom left of the configurator menu that says "busy: no list send"

Any suggestions?

 

[intrigrant]

Sounds like a DECT version one to me were you use the ADDM Manager to send the data, right?
If you get the message "busy: no list send" then it can be the PC firewall, wrong IP Address of the station, LAN not in the same subnet etc.

 

[texmatlock]

Ok. This device says it is a v2 (IPBS2-z3/1B1 V2). I have my firewall turned off. Can access the base via web browser. But from there, I am not sure how to point it towards the manager pc to pull the tftp file.

 

[tlpeter]

You are trying to use the ADMM configurator which is for the DeTeWe dect.
You are using the IP dect R4 which is Ascom originally and can only be configured from the web interface.

The V2 part menas the second version basestation of the R4 type.
Read this installation manual before you do anything else.

http://downloads.avaya.com/css/P8/documents/100073333

BAZINGA!

I'm not insane, my mother had me tested!

 

[texmatlock]

tlpeter thank you so much. I have found that the toughest thing with Avaya is locating the right documents.