How to seize a specif trunk group member

[rstockton]

Would someone be able to advise as to how to dial out on a specific trunk member. I'm testing T1 and instead of busying out all members accept the one I'm testing (using TAC), I'd like to simple directly seize and dial out on a specific member.

The switch is a Definity G3Si rel 9.

Thanks In Advance.

-rjs

 

[clausen]

You need to detemine what the "facility access test code" is set to. You can find the feature code in "display feature". Once you have placed or determined what your feature access code is, you will need to check the COR of the the station you are going to test with. It's COR must have facility access testing set to yes. OK now you are ready to test. Here is the dial sequence:

{facility access test code} {Port Network Number} {Carrier Use 1 for a, 2 for b, 3 for c, 4 for d, 5 for e} {slot} {circuit}.
IE: If the access code was 123 and the equiment location was 01C716 you woul dial 123013716 and you would get dialtone. Hope this helps

Thanks

CHris

 

[rstockton]

Thanks,

This. How would I do this on a trunk sticking out of the back of an R300. The ports at listed as:
T00001
T00002
T00003, etc....

-rjs

 

[clausen]

Good question. I'll do some checking and see if it is possible.

Thanks

Chris

 

[rstockton]

Thanks for looking into this.

-rjs