How to list Active IP Phone that are in service on CS1000 ?

[Optman]

Hi all

I need the procedure to list all IP Phones that are in service state..??

Thanks

Regards

Mostafa

 

[bigindian65]

ld 117
prt dnip 1

prt dnip 2

prt dnip 3

or whatever your numbering plan is, will give you the range.....

Mato' Was'aka

 

[dulfo666]

Or, go to each of our SigServers and do isetShow

 

[nessman]

LD 117
STAT ISET ALL

 

[Firebird Scrambler]

Also try in LD 117 INV GEN SETS. Wait until it finishes, then do INV PRT SETS to list out ALL the digital phones that are connected.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[allenmac]

I prefer the LD 117 stat iset all command mentioned above by nessaman.

This will also return the firmware version, IP address of the phone, IP address of the signaling server it is registered to, MAC address of the phone, TN of the phone, and it's state (registered, unregistered, busy, etc.)