Hotline name 1

[geirendre]

Hi, I'm trying to program a 3903-set with a Hotline-key on key 0, and with a name on the line, so that the name show's up on the receiving side when the hotline in activated.
How do I go about doing this?
Can't se any way of defining a name without an extension DN, but where shall I put the DN????
Or must i hotline to an ACD with NCFW to the target DN,
and put a name on the ACD-DN?

Regards

 

[johnpoole]

clean that up a little.. you've got an outbound hot line.. ie hot d 4 1000 to dn 1000, then name 1000.. if it's a two way hot then each end should be able to have a name..

john poole
bellsouth business
columbia,sc

 

[geirendre]

No John, I have a Hotline from set A to set B, and I
need a name to show up on set B when a hotline-call from
set A comes in on set B.
Sorry if I explained it a bit hard to understand

 

[johnpoole]

this is the key entry for a hot outbound that you can also rec a call on KEY 6 hot d 4 4940 1235.. when i pick up that key it calls 4940, if you dial 1235, my set rings.. you can make that non ringing but then name 1235...


john poole
bellsouth business
columbia,sc

 

[geirendre]

Ok, so if I understand You correct, I should do:
KEY 0 hot d 4 4940 1235 on set A,
where 4940 is the target DN and 1235 is the DN of set A?
And then I can set the name for extension 1235 in LD 95 ?