Grandstream ATA dial plan for IP Office

[Guilherme1000]

hello all!

I'm trying to configure an ATA Grandstream 8 ports to my IP Office 500.

the SIP trunk is registered ok but the problem is:

when I try to make a call, after I digit the whole number I receive the dial tone from the Cellphone interface and I have to do the number one more time. that was the only way I got it working!

I believe this is some ars configuration.

I configured the following way

1- created an userrights shortcode: 0N -> dial -> N -> ars (xx)
2- created an ARS(xx): N->dial->N->6 (line group)
3- created a SIP trunk to the grandstream gateway.

All I want is to dial only the route 0, for instance, and dial the cellphone number, without having to dial the cellphone number again.

 

[amriddle01]

Your Grandstream is not configured correctly then, the system is sending the number, I can't help with Grandstream kit though



"No problem monkey socks