Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gateway 800C, dos not boot.

Status
Not open for further replies.

Talson

IS-IT--Management
Feb 22, 2002
31
US
I have a Gateway 800C and can not get it to come up. The power light stays yellow as in stand by. I have tried to reset BIOS by moving the jumper and removing the battery. I have also removed all power plugs and cables from all drives, switched memory locations still no fix.

 
Talson,
Does the pc post?
Bob W -------------------
"If the only tool you have is a hammer, you will see every problem as a nail." - Abraham Maslow



Get more tools!
 
No, it does not. Everything in on-board and can't disable anything. I can't even get into the BIOS.
 
You may be able to access the CMOS by pressing & holding a key during bootup or unplugging your keyboard altogether. If your pc is as dead as it sounds then you should *carefully* (use of a static strap is a good habit) remove or disconnect anything that is not needed during bootup such as IDE cables, modem, scsi cards, etc. Also, if you have more than one stick of ram you should remove them (leaving a single stick in Slot 1) If you are using more than one stick of ram you should try each in slot one to rule out which might be the bad stick. Better yet, if you have access to compatable ram you know is good, you could install it in place of any in your pc now. After doing this see if the pc will at least post - if it does you will get several beeps. Let me know how this works out.
Bob W -------------------
"If the only tool you have is a hammer, you will see every problem as a nail." - Abraham Maslow



Get more tools!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top