G430 pri-trunk

[TCBOYD]

I have a g430 that I need to install a pri-t1. It is not an LSP it is registered to a 8800. I want the stations associated with this gateway to only use the pri-t1 that is installed in the gateway for both incoming and outgoing calls and not at our core location.
I programmed the route pattern and the location for the gateway. What else do I need to do?
Thank in advance for any help.

 

[wpetilli]

You could do this a few ways.. FRL/COR to restrict access to specific trunks or you can setup a new location/Network Region/location based ARS table with route patterns that have this TG you want as the first choice. Assuming you are IP endpoints you can put an entry in the ip-network-map table to point that specific subnet to the new Network Region you built. Another way is partitioning, but I'm not versed enough in that to give you exact steps.

 

[smokinjoe2938]

Then use ARS location tables to do this, as I see you added the gateway as a location number.

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.

 

[TCBOYD]

Thanks for the quick replies.
What is the command to change or add a ARS location table.

 

[wpetilli]

cha ars ana loc x xxx (dialing string)

 

[TCBOYD]

When I enter the command I get the following message "multiple locations feature not assigned

 

[wpetilli]

do a disp sys cust and on page 5 you should see the field multiple locations. Is it flagged to 'y'. Not sure if you can change that yourself.

 

[smokinjoe2938]

Then you would have to partition this new site

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.

 

[wpetilli]

if tenant partioning is on same command.. disp sys cust

 

[wpetilli]

Actually.. you could edit the options from the web interface, if I'm not mistaken.

 

[TCBOYD]

Thanks to all that replied. I was able to use the web interface to change the customer options. I will now try the ars ana locations.
Thanks again,
Tom