After upgrading 2 PBXs to Succession 5.0 these messages (ERR087) are coming out every few seconds on all TTYs. Is there a way to disable this specific message code from being outputted?
The 500 set has been configured with CLS DTN. Any DTR slots have been
idled by the calling procedure IDLE_TTR.
Contact your technical support group.
Severity: Minor
two things i would check, buffers and dtrs.. do you have your buffers set high enough and do you have enough dtr's built for both analog stations and did's
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.