I have a G3 with the fourth PRI interface setup for Tandem connection to a Cisco VoIP gateway. I can receive call in from the Cisco which is attached via PRI to trunk 10 (sig grp 4) but outbound calls (4 digit) simply gets a error tone. Any ideas how to setup a route pattern back out the PRI ? or maybe I missed something else.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Definity tandem PRI setup to Cisco VG200
- Thread starter tc0nn
- Start date
You could always use "list trace tac <insert tac assigned to trunk group here>" and try to place a call. This will tell you if it's getting routed to the trunk group to begin with, and what happens from there. Also, you could use "list trace station ####" and trace from the ext you're calling from. This should show you which trunk group you're seizing and which route the call's going.
Okay, so now I have UDP turned on, I trace the TAC but never see any Definity to Cisco calls. Any suggestions? Basically I have yet to see a call hit the Cisco unless I dial the TAC, and then I'm not sure what to do then to get it to route the call...
Ok..?
My extension on the IP side are 445x
I have: change uniform-dialplan 0
Matching Pattern 445
Len 4
Del 0
Insert _
Net ext
Conv y
Node Num _
I also have: change aar analysis 4
Dialed String 445
Total Min 4
Total Max 4
Route Pattern 7
Call Type aar
Node Num _
ANI Req n
Route pattern 7:
Grp No 10
FRL 7
NPA 214
Pfx Mrk _
Hop Lmt _
Toll List _
No. Del Dgts _
Inserted Digits _
DCS/QSIG Intw n
IXC user
Trunk group 10:
TAC 807
COR 82
Dial-access y
Direction two-way
Service type tie
Don't know what else to include...
Thanks for the help! Much appreciated!
My extension on the IP side are 445x
I have: change uniform-dialplan 0
Matching Pattern 445
Len 4
Del 0
Insert _
Net ext
Conv y
Node Num _
I also have: change aar analysis 4
Dialed String 445
Total Min 4
Total Max 4
Route Pattern 7
Call Type aar
Node Num _
ANI Req n
Route pattern 7:
Grp No 10
FRL 7
NPA 214
Pfx Mrk _
Hop Lmt _
Toll List _
No. Del Dgts _
Inserted Digits _
DCS/QSIG Intw n
IXC user
Trunk group 10:
TAC 807
COR 82
Dial-access y
Direction two-way
Service type tie
Don't know what else to include...
Thanks for the help! Much appreciated!
At this point I'm wondering if I should just route the calls like a specific npa-nxx.. So I would setup ARS and the route-pattern so only calls to xxx-yyy-zzzz go to route-pattern 7, then ars digit-convert 44xx extensions to xxx-yyy-44... Might be worth a shot.
- Status
Similar threads
