Definity logs

[TSHDave]

hi,
does the definity have any logs that show Up-Time, i.e. all the time the definity is ready to be used? and down time (not ready for use).
Thanks

 

[mikeydidit]

The Definity should always be ready for use. There are a couple of commands that can show you at least some of what you are after. The “status health” command shows the state of your processors and cabinets. The “display errors” resolved errors will show you all errors that have occurred. Any downtime will show power alarms, major alarms, and fiber links. The “status cabinet?” , will show alarms for that cabinet.

Mike Jones
LSUHSC

 

[orypecos]

If u have the command "display init" it will show u when the system came back up and if it did a software reset and what level. U might be able to figure out how long it was done from that screen.

 

[TSHDave]

Thanks guy's, i was hoping for some sort of report that would list startup and shutdown time (or something to that effect) over the past year or two.

cheers anyway