The system is a cs1000 rel.5. I just fixed a major problem with the TMDI cards. They had 3 loops that were no longer connected to the smart jacks (must have happened when they cut over to cisco). They have a fractional T1 that I have looped back to the to the TMDI card. On the telco side the IT tech I was working with could not find if the cable was going to there cisco system or to telco. So I left it loop back on both sides (just to clear the red alarm on the TMDI card). Will this cause any problems in the future?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CS-1000 TMDI Loop Back
- Thread starter rjtripp
- Start date
LittleMaster
Technical User
Looping the system doesn't create any problem.
- Thread starter
- #3
- Status
Similar threads
