Call Park, Unpark troubles , IP Office

[Wolfcub1]

I have an IP Office Small Office Edition, with 3.2.55 software.

I have some digital and some IP phones.

I programmed a button on sta 205 as:
Park Call (EXT#)#

I programmed a button on sta 206 as:
Unpark ________ (no additional info)

I make a call to x205, and park it (light turns green)
from x206, I get dial tone, press 'Unpark',and dial 205#
and I get a message 'Call Rejected'; the call does not come off park.
I tried to pick up using short code of *38*205#
No Luck??!!

Any help out there?

 

[TekceteraSupport]

For the users that you want to have access to park I program my buttons like the example below.

In button programming:

Label: Park 1 (or whatever you want)
Action: Park Call
Action Data: 1

To Add an additional Park slot create the following button:

Label: Park 2
Action: Park Call
Action Data: 2

Then program these buttons to all phones you want to have access to this Park 1 Slot or Park 2 slot...

If you want multiple park slot just change the Action Data # for each park slot and program it to the users you want to have access to it.

Hope that answers the question... or helps somewhat...

Tekcetera Support