Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bay ANH Routers - Assigning a DLCI using command line? 1
- Thread starter mixonadam
- Start date
-
1
- #2
If you currently have Frame Relay working on this router then you should find the new Dlci in the Defautl Service Record. You can move it to a new Service Record from the Site Manager screen that allows you to view the Dlci's.
If you are configured in a point to multi-point configuration (applied IP address directly to the interface) then you don't need to do anything as long as the other end is configured. If you are using a point to point configuration then move the dlci to a new Service record and configure as the others are configured.
If you are configured in a point to multi-point configuration (applied IP address directly to the interface) then you don't need to do anything as long as the other end is configured. If you are using a point to point configuration then move the dlci to a new Service record and configure as the others are configured.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question