Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

7206 PA-4E Config

Status
Not open for further replies.
RadioX

RadioX

IS-IT--Management
Joined
May 15, 2001
Messages
145
Location
US
How can I configure this to run at full duplex on my 7206.

I go into the config for the interface (eg ethernet 4/0) but there is no duplex command. I am running IOS 12.0(7)T

Thanks
Ron
 
Sort by date Sort by votes
I don't think you can. Technically speaking full duplex is only a 100base-T feature according to the IETF.
----------------------------------------
Wassabi Pop Tarts! Write Kellogs today!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Jared R
  • Locked
  • Question Question
Cisco UC320W Paging Help
Replies
0
Views
696
Jared R
Jared R
WinstonCH
  • Locked
  • Helpful tip Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat
Replies
1
Views
893
BIS
BIS
stanlyn
  • Locked
  • Question Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
646
iggsterman
iggsterman
Drug_Store
  • Locked
  • Question Question
Cisco 3560g 48ports PoE - config
Replies
1
Views
270
Drug_Store
Drug_Store
bfordz
  • Locked
  • Question Question
new help on setting up third party VoIP phones through Catalyst 2960x switch
Replies
0
Views
354
bfordz
bfordz

Part and Inventory Search

Sponsor

Back
Top