Search results for query: *

We think it's a bad card too so we are getting another one so hopefully that fixes it.

I tried to install a VCM8 into the ip406 but after installing the card and re-powering the unit it just flashes all the lights goes green and then after a second or two goes to a orange then red main light and then goes through the reboot light show again. It keeps doing this and never actually...

The system is VERY old. Works very well but it is old. It has 3.2 loaded on it and it won't let me upgrade any higher. The manager version we are using is 5.2 but 3.2 is what is actually on the PBX. Below is what I get out of the monitor when I log in. I ordered a VCM 8 card for it that should...

I check in the monitor and I didn't see VCM but I saw VCOMP and I am guessing that is voice compression channels. It shows that I have 0. So just to check I popped the top on my 406 and sure enough I have no VCM card in it. I have seen I can pick them up online for about 70 bucks. Would I need a...

I have found the H323 settings and it looks like I must have a VCM card in the 406. I just need help with the settings for the asterisk server and the setting for the avaya at this point.

It's not so much that I don't know the IPO it's more that I am moving into areas I have not worked with before. I setup the IPO have it running perfect and have had no issues. The reason this is more complex is that I am trying to trunk it to another PBX and I am used to working with POTS lines...

How would I check to see if I have one installed without opening my IP406?

I don't have VCM and to boot the two slots on the back of our PBX are full. I was hoping to somehow connect the two via the LAN they are on together.

That was my thought but I can't find any walk throughs on how to do it with a 400 not a 500 so I'm a bit lost. Also I didn't know if you could run the SIP trunk through the LAN ports on the front. Our Avaya has pots lines in the expansion slots in the back so I didn't know if the SIP trunks...

I am trying to figure out how to connect these two so extensions can call each other from side to side. Our company runs a dialer called VICIdial that dials through Asterisk for outbound calls and has an Avaya ip406 for all the other phones in the office. We would like to be able to transfer...

One of the thoughts I had was to use Fiber Optic to go from the main box (ip406) to an expansion module and put the module in the office. I could then have another Fiber Optic line for my data. Any thoughts on if that would work?

I am new to IP Office and this forum so I;m sorry if this has been answered already. I looked around and couldn't seems to find an answer to my question. I was recently handed the keys to a interesting IP office system (ip406 v2 based). It is at a factory with an office building about 50 feet...