Search results for query: *

Hi, It might depend on what is the type of wan link you have got. Is it a T1 or a E1. What is generally the utilization in your network? Raj

Hi, You seem to be talking about load balancing. CEF with OSPF can be done if the links are of equal cost, which is not in your case. You can use multilink ppp or ATM Inverse Multiplexing device to load balance traffic. Otherwise you can also use linkproof of www.radware.com Raj

Hi, I had faced a similar situation when i had loaded a new IOS and the router did not detect the ports. I had to load the previous IOS through the console port using the xmodem feature. Raj

Try the following: 1. Download Cisco Config maker software by searching in www.google.com. Draw the diagram there. It will give you the configurations. 2. If you have a little time try using dialer maps. Raj

Try the following steps: First...Find out if your isdn line is working fine. Second.....Run the command sh isdn status. Layer 2 status should show Active Third.....Check whether you have given the required authentication Fourth.....Remove the Backup commands. Try dialing manually by using...

Is tftp allowed through your firewall ?

Hi, You can upload the software using telnet. make ur machine the tftp server. tftp software is freely available on net. download the latest software from 3com. Connect your machine to the switch. Telnet into the switch. Select SYSTEM > SOFTWAREUPGRADES > give the ip address of your machine...

Hi, I have not seen such a thing but a similar kind of thing. The lights of my 4900 switch went on and stayed like that. I had to reload my Software. Tried reloading the latest software on to your switches. The problem might be solved. Raj

Hi DevonBoy, I have faced some similar problems. I advise you but cannot guarantee you that it will work. Restore all the switches to factory defaults. Load the latest software in all the switches. Also the software loaded in all the switches should be of the same version. Actually this is not...

EIGRP is calculating fastethernet port ( 10/100 MBPS) as the best path. That is why it is not using the frame relay connection but the lan connection. Regards Raj

I will give the example of netscreen firewall. Netscreen firewall has got three ports: untrusted trusted dmz untrusted port is given the legal ip and is the outside port of the network connected to router. trusted port is given a local lan ip and is the inside port of the network connected to...

Do u mean to say you want to use a 64kbps line for internet usage and also for voice applications. Then u will have to for a modular access router, through which u can connect your leased line. A modular router has got a network module in which you can place the equipment required for...

Hi, You need not do telnet to upgrade the firmware. You can access your switch by typing the ip address of your switch in internet explorer. From there you have to select the options. Then install a tftp server. In the directory assigned for tftp put the firmware in that directory. Rest you...

I dont think you need to do anything with the auto negotiation. i feel autonegotiation has much to do with the port speed. Set your switch to default settings and try. Regards Raj

hi, The option is there in the gui mode. Give the ip address of the switch in your internet explorer. You will be able to see the gui interface. Raj

Hi, I experienced a problem with 3 Com switch. My whole network use to die down. Previously what i use to do is restart the 3com switches. The best thing you do is set all your switches to default factory settings and then try out and keep the settings of all the switches in the stack same. Raj