Recent content by wpfaff

Here are two utilities that will do what you want. http://www.uxd.com/wst.shtml http://www.pccertify.com/products/whatmem.htm

go to this link http://www.americas.creative.com/support/files/download2.asp?centric=108&maincat=11&os=1&subcat=16 Download the updated file. This is the complete driver it's listed as an update. This only means that it is the latest driver available.

Try this link with the laptop and test the sound card if you haven't already...

Unless the mouse came with the adapter or the mouse package said that it would work with a serial adapter it won't work. I dont understand that you can put your com port adapter on but one way. Your com port that your using should either be a 9 pin or 25 pin male socket. Your adapter should be...

Have you went to the printer manufacturers' website and look for an XP driver?

Take out the memory and replace 1 stick at a time. Boot and see if it posts if not the try the other stick. This memory doesn't appear as tested memory for this board. Dual channel can be very fussy about the memory. Both modules have to have the same exact specs. Got o this link for tested...

I would buy a SATS drive only if the motherboard has this capability. The serial to parallel converters are causing problems on older computers(made within the last 3 years).

This could also be a power supply problem. Do you have the equipment to check the power supply?

Yep that's about right. Be sure that when you purchase your memory either buy a dual channel kit or that both modules have the same specs. Including cas latency(cl), buffered or non-buffered, ECC, Parity or non-parity and Mega Bytes. Even then there isn't a guarentee that they will work in dual...

According to Asus the following Corsair 400 DDR chips are qualified for optmium speed and reliability for this board. 256MB CORSAIR CMX256A-3500C2 Winbond W942508BH-5 512MB CORSAIR CMX512-3500C2 Winbond W942508BH-5256MB You can use only 1 set of 2 of the above chips on the board. You also...

I would remove all cables and power cords to the HDD's except for the one that you have your operating system on. Make sure that the jumper is set as master, make sure that the HDD cable is on correctly(red stripe and pin 1 on IDE port and HDD.)and that the power cord is plugged in correctly and...

Have you always had this problem with this drive? Did you go into your DiscWizard maintanence menu and try updating your Dynamic Disk Overlay?

Is there 65 errors or 65 bytes. Does it tell how many bits are affected? The problem is that 1.08 Gigs isn't very much capacity if this is a windoze machine. When you format this drive the formatter is going to mark all of the bad blocks and your going to have even less capacity. Put this...

If your HP has been built in the last 3 years then a standard power supply won't work. But go to this link and enter your model number . http://www.affordablesurplus.com/ps-selector-hp.asp I found one for mine and it was only 39.99. Be sure that the power supply is bad because there are...

There are 3 ways you may be able to go with. 1) Get an adapter card which contains its own bios. Maxter has an ultra ATA/133 PCI adapter card. Its made by Promise Technolgies. I have used this in Pentium 120mhz and higher. You will have to go into your bios setup and show that HDD's are not...