Recent content by rpwall82

sorry for no update for awhile been busy....ran test tonight here are the logs... 5756] 01/29/06 22:39:35 TF_InitMediaServerReverseConnection : Data Connection information : connection established between IP 127.0.0.1, port 2854 and IP 127.0.0.1, port 2853 [5756] 01/29/06 22:39:36 AddDataExtent...

Issue resolved...there is two ways to Configure SATA on this BIOS...RAID and Non-RAID Plug and Play... However...setting up for RAID with a RAID 0 configure allows for loading a SATA driver update from VIA that updates SATA/Microsoft driver date from 2003 to 2005. This caan be done without any...

Hi, I am running Winows 2003 Enterprise Server and doing some testing I have installed a WDC WD800JD-08LSA0 Serial ATA Drive. When copying or using any fuctions on Serial ATA drive the CPU spikes to 100% and it takes 26 Minutes to copy a 4 GB file. I did a second test on IDE interface with a...

No can you supply the the means to throw both these in debug mode....funny it catalogs it it with no issue....

Ok maybe someone can help with this..... I have say 10 tapes from an arcserve session tape 7 is missing.. I used Tapecopy (ARCServce utility) to copy tape 8 to a new tape say tape3 (name with a sequence number of 1) I loaded Backup Exec 10.1 (netbackup does not read arcserve tapes) and it...

Actually I have made some headway into this... I used Tapecopy to copy tape 8 to a new tape say tape3 (name with a sequence number of 1...I loaded Backup Exec (netbackup does not read arcserve tapes) and it does catalog all files from tape 8...but when doing a restore it crashes the remote...

Any apps out there that can read and restore from arcserve tapes besides BackupExec 8-10x? Thanks

Stupid question here can this motherboard operate with 2 sata hard drives running as well as 4 ide drives...if you have corretc power supply...thanks

I already have restored the data from 1-6, 7 is gone and 8-10 has same session info and data as 1-6. But if there are third party vendors that can recover this, then there must be a way. I even opened a call with CA with no luck...I mean it makes no sense to have a database with pointers if...

This is such a single point of failure with this product there has to be a way...I cannot believe CA would let this be...You should be able to do a restore and skip over the tape 7 and go just to Tape if you knew files names on tape...I do not need to merge or scan I have an intact Database just...

This is such a single point of failure with this product there has to be a way...I cannot believe CA would let this be...You should be able to do a restore and skip over the tape 7 and go just to Tape if you knew files names on tape...I do not need to merge or scan I have an intact Database just...

Can data be read from a tape session if database is good but missing a tape in sequence example session 1, tape 7 is bad Session has 10 tapes can data be recovered from tapes 8-10

I have a session of 10 Tapes Tape 8 is bad and unrecoverable.. Is there anyway to restore data from tape 9 and 10? it keeps asking for tape 8 during restore... any help would be greatly appreciated