Recent content by railugh

I utilize 3d studio max4 for animation design, though an oxygen card is one of the most promptly powerful resources, I use a Geforce2 TI in my home system. The transform and lighting in the hardware offers great performance on rendering times. The software you are utilizing should get a decent...

I can not say that the problem I had prior is in relation to yours, but worth a shot. If at anytime the battery was recharging when I would access my dial-up the same blue screen of death would occur ... which made access impossible altogether just running on the battery. Try backing the battery...

I'm not sure if this pertains to your situation or not .. but in the past I had a few situations like this and it turned out to be the front bezel of the case ... the case fans were causing a minor vibration, you press on the pane it would stop for a bit then return ... of course i had three...

http://www.ecsusa.com/ecsusa/www.ecs.com.tw/download/driver/k7s.htm the above link will provide you with the most recent drivers for you MB the following will provide you with the bios update and the revisions made http://www.ecsusa.com/ecsusa/www.ecs.com.tw/download/k7s5a.htm hope this...

perhaps you could check for recent motherboard drivers, this can help with ide or bus mastering issues. If you only have one hard drive and one cdrom then you should not have to alter slave settings or cable positioning. The hard drive will be detected as primary master and the cdrom as a...

the last instance I encountered was with a Creative 52x cd and I believe the burner was a Wearnes CDRW 8x4x32... the burner was set as slave with the creative as master both on the same IDE cable ... adaptec sofware was utilized in the burn process as HiLiKus stated , on the fly transfers data...

I have recently encountered a few systems that hold both a standard CDROM and a CDRW (most linked on the same IDE cable) that have had the standard CDROM fail after a burn on-the-fly. Fail meaning the cdrom no longer recognizes dics at all even though the burn process completed. I have seen a...

You may want to alter your air circulation in the case to resolve some heat issues ... make sure you have some intake as well as out ... and put a fan on the video card if one is not present. You should check into the wattage of your power supply ... even though the geforce2 uses lower voltage...

Jake The pin arrays vary from design and will continue to do so. in that part you are correct, 'the physical design is different' but the transistors, the core of the processors are constructed from the very same silicon wafers. The external appearence does not change their internal...

Pentium and Celeron chips run right off the same manufacturing line ... yep, side by side ... however Celeron chips are mere Pentiums that didn't pass the complete Quality assurance demands ... thus some of the processor features are disabled and it's speed rating reduced. The same applies to...

It is unlikely the OS would cause this issue ... confirm the motherboard jumpers and the frontside bus speed ... an Athlon 1.4 with a 266FSB will register just over 1.0 if set to a 200FSB configuration may need more info as to MB type to confirm

Due to the age of the motherboard, it is possible that your AGP slot is not 2.0 compliant. Although a BIOS update may assist in this issue it is unlikely to completely resolve the problem. I had a similar problem with a geforce2 mx that caused multiple lock-ups on an older system and had to...