Recent content by Multidisadvantaged

Thanks, I had seen that doc but was after a little more detail on implementation. Managed to find some more detail in the Administrator Guide for ACM. Gonna have to wing this one a bit!! Thanks again.

The "Change Uni Ana" command will let you add a number.

I wonder if any of you have set this up before. I fully undrstand the principles of this but I cannot find any documentation that shows you how to set this up. So far I gather that it interacts with the CAC feature and that it is all set up from the IP-Network-Region form but I need more...

Hi, Can anyone tell me how to configure the QOS values for softphone? I believe that the values are taken from the Ip-Network-Region form. I have Packet Scheduler enabled on the PC's network connection. When the data port on the data switch is monitored it is not showing any 802.1p/q...

Does anyone have any experience of 4602 handsets getting hot to the touch. I vaguely remember a bulletin or PCN about this around 12 months ago, but can now find no reference to it. Anyone else remember, or am I imagining things? Trying is the first step on the road to failure

Same principle for the LX. Use a browser (I.E) and enter the ip address of the connection (10.n.n.n) into the address bar. This will bring up a login screen and away you go. Trying is the first step on the road to failure

Can any of you guys tell me at which s/w release SAT access through a CLAN board became available? R7/R8 etc etc. Thanks in advance. Trying is the first step on the road to failure

In that case check the vintages of your analogue boards. If they are TN2215s between vintage 10 and 12 then that is the problem. Try a different vintage or a TN2183 or TN468b instead. Pretty sure this will be the fix. Trying is the first step on the road to failure

Been through that doc too. Thanks again. Trying is the first step on the road to failure

Skara, Thanks for your response. Already done this. Trying is the first step on the road to failure

I have a problem installing an IA770 onto an 8300. On a list con all it is showing no board, and I have tried a second daughter board with the same result. On the maintemance web interface under view process status the messaging shows 0/1 down. The server has been restarted several times...

This can be resolved on the DS1 form. Change the DCP/analogue bearer capabilty to "Speech" instead of 3.1k. Should resolve this problem. Trying is the first step on the road to failure

Hi, You need to check ip-services (change ip-services.) In here add a SAT session and enable it, the local node is the node name of the clan add a tcp port (9002) and the remote node set to any: change ip-services Page 1 of 3...

Thanks all, will try these. Regards Adrian. Trying is the first step on the road to failure

Can anyone tell me how to find out what version of Informix I have running on a CMS? Thanks in advance. Trying is the first step on the road to failure