Recent content by markpridgeon

Did you get a fix for this problem as i have the same problem.

Did you get a anwser for this problem as i have just found it on one of our swtich's

MCP2000, i am just working on a fault that you posted a tread for last year to do with the TN793CP boards i am having a simular problem with modems on this board and just wondered if you managed to resolve the issue as it said you were testing the back plane.

I have a Site with a S8300 and two G700's connected via the stacking modules, they are using the Digital extensions a IP soft console and the Avaya conferencing bridge. Below is the setup. 001V1 ICC MM S8300 B HW02 FW001 001V2 DS1 MM MM710 A P HW04 FW015 001V3 DCP MM MM717 A P HW02 FW004...

We have a customer with 2.1.3.1 software and they have installed a new pc and they require the software, they have lost there disk. We have sent them 2.4 but they are saying it need to be 2.1.3.1. They have tried to install 2.4 but can not get it working, I have had no exposure to the BCMS so I...

I believe the call should return to the sender and not go to VM, what might be causing an issue is maybe the call is going before 4 rings and you are hearing the VM ringing twice you should really make sure of the timings and not go of the number of rings.

Thanks for that info i have also found in the hardware ref guide that you require the BP version for the G650.

Can anyone tell me if it is ok to use the IPSI AP version in a G650 as i have just read in the Min vintage Doc on Avaya website that you should only use the BP version in G650. I have a site at the minute that all the phones cant do anything ie go off hook every now and then and they are using a...

I dont suppose anyone knows if i can download a image of CM 2.2.1 from any where do they

Thanks mate i will check this out.

I have got a problem on a G700(a stack of two) with S8300 and Pri card, all works fine but every so often we get calls coming in which connect but you get silence on both ends. we have run some traces and it seem that the system sets the call up but then doesn't setup the audio channel. We...

I have just installed my first S8700 and i am having problems with the ipsi card. i can ping the card from th system and i have upgraded the firmware to v12 but when i run a test on the port it comes up with no board installed and in the show cir page i am see no cards. can anyone advise!!!