The problem I am faced with is that I dont get the same option as you have shown below ,
When I do a "ch syt par ipsi" I dont see ip addresses
Nor do I have the option , all DHCP options within
the servers are off .
Why or under which conditions am I not given the option to fill in the IP...
4Merlucent , list conf all shows 01A tone/clock only
Test LED brings the leds all up , they are fine
Petran ... I programmed the IPSI through the services port
set control interface ip address & subnet , show control
interface shows the correct address
I am of the opinion that "cha system...
To answer the questions :
I am connected at the front RJ45 direct into the IPSI
it is a strait cat 5 into a small switch and then into the
Ethernet 0 on the S8700
"ch system-parameters ipserver-interface will not even
allow me into the IP address field and no there are no IP address values in...
I am having problems connectiong the S8700 with the G650
While I can do a display IPSI version and I can ping it
it still does not communicate , I even tried loading
version 22 firmware . Below I have the spects in the units :
C.M 2.2
Ethernet 0 Control Network A
Server 1...
I am setting up a duel S8700 system , I am currently
going through the first unit , so far C.M 2.2 is installed
license and authentification files are in , the problem
I have is that the IPSI will not register .
IPSI version shows it fine throug the web mant. page .
I can ping it and it come...
I will assume that this delay is over a T1 or E1 trunk
check and see what is in the "digit handling "option on the
first page of the trunk , incoming and outgoing , both should be enbloc rather then "overlap "
Do a change tr xy and look at the first page . look for
enbloc/enbloc.
Also a...
Iam setting up a duel S8700 , all is well until I reach the
license file load , The responce from the server is :
"command failed platform type / offer type mismatch" .
I have tried to re-load cm 2.2 again with the same result .
This is on the No 1 server . I have not tried on the second...
I have downloaded the service pac below and downloaded it
only to be presented aith another error .
ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/commgr/samp-update-AVAYA_S8500_1_0_SP2_BUILD_17.tbz
The Error says that the file type is wrong and it must be a
file type of .tar
All out of...
Thanks AvayaEng
You just beat me to it , I was going through the support pages and downloading PDF files , Patches etc .
The only part that worries me is that the service pack
must be done during installation , well I have all the
Translations already programmed and I am reluctant to
go...
Many Thanks for your replies .
I would be glad to call Avaya to fix the modem problem
but for them to look at the problem the modem must answer.
I assume no other modem will do the job either and
Avaya will not use P.C anywhere through a different modem.
Any further assistance would...
Thanks 4merlucent , but I have done exactly that , I test the modem in both modes and the result is a pass
when I try to enable it I get the following error
/usr/bin/sudo: no passwd entry for samp!
error: RunSampModCtl: "/opt/ecs/sys/sampmodctl -off" failed with status 0x100
error...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.