Recent content by fmielbye

help! I need to make some updates to the company speed directory but it's been so long I forgot what to program to give me access to make the changes. I have a personal list only(SCC) Can someone point me in the right direction as to what I need to do to add access to my set. (3904) Thanks

I'm brand new to the BCM50. A multiple part question. I installed a BCM50 and the add on at a jobsite for about 20 users. The main unit only has 2 lines/ 12 users. It's working great. 1. I added the module but the main unit does not recognize it. According to my vender it is licensed to...

thanks guys. i found it in the ntp's right after I submitted the question. Thanks again

Can't find where to add the module on the TN. The 2616 you change to AO1 but that option is not on the 3904. Can someone guide me through this? very much appreciated. Fred

I purchased some digital licences but I'm not sure how to add them to the switch. They came on a 3 1/2 floppy key code diskette. Is this a simple process? Thanks

thanks

Can someone tell me what the default IP address is for the BCM50? I'm a PBX administrator so I'm new to the BCM family. I was told that once in Elimant Manager I would be able to access the install guide. Any guidance would be greatly appreciated. thanks, Fred

Figured it out. Thanks once again for your help.

Thanks John. I'm begining to see the light. Once in 15 how do I add table 1. Chg Net Thanks

Hi, I recently added a block of 40 DID's to a PRI terminating into an Option11. The new DID's have a prefix of xxx-788-xxxx. The exsisting DID's are all xxx-585-xxxx. I programmed a few phones using the new DID's and when I place a call to them with my cell, xxx-788-xxxx it reaches the phone...

You guys have been a great help. Thanks

I have about 7 DID's progammed begining with 71xx. The LUDN displays 710 711 712 713 714 715 7161 7166 7169 717 718 7190 7191 7194 7195 7196 7197. I thought each number displayed individually. I guess I'm ok correct? Thanks

ok thanks. I'll try that. Fred

No. When I ordered the PRI 3 years ago I ordered some extra DID's in the 71xx range. Not using 7 for anything. thanks

Hopefully a simple one here. I have 4 blocks of DID's on a PRI that have not yet been added to the PBX. ie, when I do a LUDN they are not there. How to I go about adding them to the PBX? Thanks a lot, Fred