Please help!
In this situation, I'm using a LaserJet 8000 and a 500x JetDirect box (3-port). The printer is connected to the jetdirect box via parallel and the box is connected to a 8-port hub via network cable. The hub is then connected to our network.
The pc is using windows 2000 and is...
I have a HP Photosmart 7550 and a pc with Windows 2000. Whenever I turn the printer off and then on again, the monitor developes vertical colored lines across the entire screen and I need to do a hard shut down (because I can't see beyond the lines). I turn the pc on again and everything is...
I can't open the deleted foler. The same error comes up. doing a shift/delete permanently deletes the email without going into the deleted items folder. But I still get the same error again.
Using Outlook 97. I can open the pst, however, I can't view the different folders. It tells me that the file exceeded it's maximum size. Then it tells me to shift/delete emails to make the file smaller, but when I try to do it with some emails, it gives me the same error. I would like to...
I'm running Windows 2000 with Outlook 97. Just today I began receiving emails that are absolutely blank. No sender, subject, body, nothing! I tested the account and even good emails are being received with nothing to show. Does anybody have any suggestions as to what's going on?
I'm trying to figure out why a pdf document prints faster using the driver through Windows (8100 Series PCL) then the driver from HP (8100 PCL 5e or 6). I'd use the driver through Windows, however, it lacks the options of the printer, where the HP's 5e shows them. The document contains text...
I found out that yes you can add an additional parallel port to a pc to connect more printers. When you setup the driver use LPT2 as the printer port. I think you may also add a third port and assign LPT3 to it. Thanks for everyone's help.
I have Windows 2000 and I installed PowerDVD 4.0 with a CDkey, however, after 3 minutes of watching the movie my laptop freezes and I have to reboot. Any suggestions? Could it be that I may not have enough RAM? Thanks.
I'm trying to create a report in Access where I need to move the text diplayed in a text box from the traditional left to right, to being displayed bottom to top, as if you're looking at the report from the side. I would like to know if I could do this. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.